1 Answer - Sort by: Date | Rating
go under the hood by the light that needs replacing and you will see wires coming out of a plastic holder thing you twist that and it should come out then you replace the light and install the holder thing back into its original place
0
0
- What Does Resister?
- What Is Economical Fuel?
- How Many People Dies Yearly To Drunk Driving?
- Is There A Break Booster On A 97 Taurus?
- Why Do My Brakes Grind When Wet On My 2007 Buick Lucerne?
- What Is The Meaning For Supra Molecular?
- How Do I Get A Free Wiring Diagram Of Peugeot 206?
- Where Is Spare Tire Located For A 1995 Jeep Cherokee?
- Van Van Shakes When In Drive Not In Park?
- 1993 Chevy Lumina Van Shakes When You Put It In Gear?
- How Do I Get Tires Set Straight Up And Down?
- Is May Bach Is An World Costliest Car?
- What Do The Dash Lights Look Like?
- What Is The Purpose Of The EGR Sensor?
- My EGR Sensor On My Ford Taurus Blew Out I Replace It But My Car Is Still Back Firing ,what Else Causes The Car To Back Fire?
- How Can I Get Lighter Fluid Out Of Clothing?
- Why Am I A Looser?
- How To Install An Oil Pump On A 3.4 Lumina?
- I Have A 1996 Dodge Ram 1500 When I Press On The Gas Pedal It Has This Clicking Noise From Under The Left Side The Harder I Press The Pedal The Faster The Clicking Is If I Let Off The Gas It Goes Away What Could This Be?
- 1996 Dodge Ram 1500 When I Press The Gas This Clicking Sounds Happens The Harder I Press The Faster It Clicks If I Let Off Gas Pedal It Goes Away What Is This?
- Is There Good?
- Why Won't My Truck Start? The Engine Turns Over. I Did A Tune Up About 3 Months Ago. 1999 Chevy Silverado 4.3L V6
- How Do I Take Off The 4wd In Kia Sportage 2000?
- How To Code ATM In Turbo C?
- Where Was Vitus Bering Living When He Died?
New Comment - Comments are editable for 5 min.