1 Answer - Sort by: Date | Rating
It really depends on make and model of car but i its a newer auto you have to look for the tensioner which will have a square slot on it where you can use a 1/2'' drive ratchet to loosen the tension so that you can install the belt and if it does not have a tension pulley there will be adjustment screws on the bracket of the pump that you will have to loosen and then slide the pump so that the belt will go back on
0
0
- How To Change Ball-joints?
- How To Change Ball-joint?
- Why Is My 1991 Dodge Stealth Stuck In Limp Mode?
- Where Does The Wire Go From The Oc Sensor On A 1990 Silverodo?
- Where Does The Wire Go From The Oc Sensor On A1990 Silverodo 350?
- What Type Of Closure Device Allows You To Set The CPO Hood To The Desired Fit?
- Where Is The Thermostat Housing On A 2001 Aurora?
- Which Type Of Heat Transfer Reduces In A Vacuum Flask?
- How To Change Speed Sensor On 99 Plymouth Grand Voyager?
- Why Is 2000 Dodge Stratus Oil Light Coming On And Running Rough What Idle When Warm?
- How Do I Replace The Light Panel Rheostat On An Oldsmobile Alero?
- How Cooling And Heating Affect Materials?
- How Do You Find The Mean Of 8,6,5,10,19,3?
- I Have A Corolla Verso Automatic But After A Long Drive It Goes Out Of Gear Then I Have To Wait For About 15 Minutes Before It Goes Back In Gear?
- What Dose Rough Mine?
- How Do I Repair Stripped Rocker Arm Bolt?
- How To Replace Glow Plug?
- How Does An Strombolian Starts?
- What Is Enternal Check Controle?
- What Oil Do Ford Transit 2.5 Engine Use?
- How Do I Change Front Brake Pads 98 Mercury Marquis?
- What Size Speakers In 2004 Dodge Dakota?
- I Want To Know How My Future Will Turn Out To Be?
- When Was Judy Schrader Born?
- How Do You Adjust The Rockers On A Daewoo Nubira?
New Comment - Comments are editable for 5 min.