1 Answer - Sort by: Date | Rating
You have to remove the steering wheel and the c clip snap ring and the retaining spring and possibly the turn signal switch so you can get to it and there will be a hole in the body of the switch you have to stick a paper clip in this hole and push the spring loaded release
0
0
- Why Did The Ranger$ Brake Up?
- When Was Transportation Made?
- How Fast Does A Honda Trx 250 Go?
- Where Is The Air Cleaner On A Dodge Durango?
- What Is The Spark Plug Gap For 2003 Ram 1500 4.7?
- How Much Does A Used Airflow Meter Sensor Cost For A 1986 560 Sel Mercedes Benz?
- CAN I REPLACE 195 65 15 WITH 205 65 15?
- How Do I Check The Ignition Circuit On A Atv?
- Can You Use A Dremel Tool To Cut A Mirror?
- 98 Lincoln Skips When It Rains?
- How Do You Open The Trunk For A 2006 Pontiac Grandprix?
- Where Does The Ground Wire For Wiring Harness On A 2002 Dodge Stratus?
- Are There Any Elderly Driving Laws?
- How Do I Change License Plate Bulb In 2006 Ford Focus?
- What Precautions Should Be Implemented To Make Sure The Elderly Are Still Able To Drive Safely?
- Where Does The Ground For Wiring Harness On A 2002 Dodge Stratus?
- How Much To Fix A Transaxle Leak In A 2000 Ford Focus?
- How Do I Get Rid Of The Air Bag Light On The Cadillac Seville?
- How To Remove Gas Tank In 1992 Chevy S10?
- How To Unlock The Sliding Door On A Kia Sedona When The Child Lock Is Broken?
- Brakes On My Chev Silverado Go To The Floor After New Brake Lines Installed And Bled With No Air In Lines, Why?
- How Do I Change A Car Thermostat?
- How Do You Prime An Engine For A 2004 Chevrolet Duramax Diesel Engine?
- Why Do My Brakes Go To The Floor On My 1999 Chevrolet Silverado As The Brake Lines Have Been Bled And There Is No Air In The Lines?
- How Do I Know If I'm Putting Too Much Fluid In My Malibu?
New Comment - Comments are editable for 5 min.