The easiest way to install rolled roofing is get your list of materials which would be plastic roof cement, 1 1/2 inch galvanized roofing nails, Rolled roofing 1 role does 1 square which does a ten by ten area, Fabric I prefer cotton fabric (membrane), gloves,troul,,paint brush,broom or blower, and aluminum roof coating,Ok lets get to work 1.clean off the roof of any dirt leafs ect broom it or blow it with a blower must be clean 2.roll out your roll roofing starting at the bottom the end with the line facing up roll from one end to the other get it straight with the bottom edge then once its straight back roll it half way, lace the edges and middle with plastic roof cement step down do the same to the other side.3 nail behind the line with your nails on the roll roofing make sure the next layer of roofing coveres the nails and on and on you go,If your roof does not have a good pitch then 3 course the seams.The way to 3 course is a thin layer of plastic roof cement, fabric and another layer of roof cement to cover the fabric you do this on pipes, canales,seams,and the edges of your roof and probably your tie in,Hope this helped you out LAST paint all your 3 coursing with aluminum roof coating this wll add 5 years to your roll roofing Use a roller and brush
