Transmission Slipping, What Is Wrong?
My 1995 Mercedes slips in reverse ONLY-- all forward gears are fine. This started yesterday suddenly-- it was 110 here in Az.
1 Answer - Sort by: Date | Rating
Start the engine, pull the dipstick, wipe it off and check your fluid level.
If the fluid level is full, then the reverse gear clutches are probably worn out.
Most everything, like, shift timing & shift quality on a Mercedes transmission, is controlled by the vacuum modulator, but reverse gear is controlled by hydroulic pressure to the reverse clutches.
If it does not engage, it is probably because the clutches are worn out.
This, (and I'm sorry to tell you), would require an overhaul.
If the fluid level is full, then the reverse gear clutches are probably worn out.
Most everything, like, shift timing & shift quality on a Mercedes transmission, is controlled by the vacuum modulator, but reverse gear is controlled by hydroulic pressure to the reverse clutches.
If it does not engage, it is probably because the clutches are worn out.
This, (and I'm sorry to tell you), would require an overhaul.
1
0
- Why Does The Car Heat Up?
- Where Is A Fuel Filter Located On A 2004 Dodge Intrepid SE With A 2.7 V6 24 Valve Dual Overhead Cams Front Wheel Drive Sedan?
- What Are The Kinds Of Lever?
- How Will A 1996 Oldsmobile Aurora North Star Act When Coil Pack Is Bad?
- Where Is The Fuel Pump Relay Located In A Peugeot 406 Model?
- Where Do I Find The Fuse For The Alternator For A 2004 Honda Accord?
- Who Has Need For Speed Shift Registration Code?
- Is P0731 1st Gear The Same As P0733 3rd Gear On A 99 Eclipse Gs?
- Where Is The Horn Fuse For A 2004 Dodge Ram 1500 Truck?
- Where Can I Get A Free Repair/service Manual For The 2001 Pontiac Sunfire?
- Where Is The Stick For Transmission For Pontiac G6?
- What Park Did George H.w.bush Dedicate?
- How Do You Remove The Bed From A 94 S-10 Pick Up?
- How Can I Bleed Air From 99 Ford Windstar Front Left Brea?
- How To Set The Timing On A Seat Ibiza?
- I Changed Engines In My 94 Honda Civic. From A 8 Valve To A 16 Valve. Now It Shifts Hard Into Each Gear (automatic) Shifts Into 3rd At About 3400 Rpms What Might Be The Problem. Do I Need To Change The Ecu?
- What Size Socket Do I Need To Change Wheel Bearing On 99 Yukon?
- Where Is Bank One On A 2001 Ford Focus Se?
- What's A Converter?
- What Is 2nd Base?
- How To Protect The Generator In Overloded?
- High Pitch Transmission Sound In My Nissan Sentra 2007 When Driving Uphill?
- What Are Basic Parts Of Ms Access Window?
- How Can I Put #in?
- How Do You Turn On The Dome Light And Open The Trunk Of A 1988 Buick Skylark?
- Is My Transmission Repairable If It Is Slipping ?
- How Can I Troubleshoot Slipping Transmission?
- Transmission Comp. Slipping. What Is This? Thanks
- What Can I Do For My Slipping Automatic Transmission?
- Can To Much Flu-ed Cause Slipping On A Transmission?
- What To Do If A Transmission Is Slipping On 1994 Toyota?
- Transmission Slipping In 1995 Galant When Cold,why?
- My Car Transmission Is Slipping When It Heats Up, What's The Problem?
New Comment - Comments are editable for 5 min.