Guest
1 Answer - Sort by: Date | Rating
Remove the steering knuckle. U need to remove the outer tir rod, ball joint, and possibly the strut from the knuckle. Then remove the axle nut(the big nut in the middle of the wheel), then just pull. It will come out. There is a little spring clip holding that in. If the cv joint seperates, then just get a pry bar and pry it out. Its that simple. Hope this advice helps
0
0
- How Do I Change An Alternator On A Ford F350 7.3 Diesel?
- How Do I Change Alternator On A 1996 F350 Diesel?
- Where Can I Find Free 2004 Ford Explorer Repair Manual?
- How To Install A Water Pump On A2000 Chevy Cavalier?
- What Dies Marie Mean?
- Is There A Fuss For Brake Lights?
- How Can I Check To See That I Am The Registered Owner Of My Vehicle?
- Kia Has No Power And Skips Bad?
- How Can Check To See If My Name Registers As The Owner Of My Two Cars?
- How Many Pounds Of Freon Lincoln Ls?
- Where Is The Relay Located In A 93 Ford Aero Star?
- Where Is Pcv Valve Located For 2004 Caravan 3.3 Liter Motor?
- How To Change A Cowl Seal?
- Where Is The Pvc Valve In A 1998 Park Ave?
- 1991 Kia Sephia Skips When The Throttle Is Engaged?
- Where Is The Fuel Filter On A 2001 Plymouth Neon?
- Where Is The Thermostat On A 97 Nissan Pickup?
- Were Is The United Stops At?
- What Is The 0-60 Time For A 1993 Mercedes Benz 300E, With A 3.2L In-line 6?
- Where Is The Diagnostic Port On A 2000 Mercury Cougar?
- Where Is The Day Time Running Light Module In A 1993 Mercury Grand Marquis?
- How Do You Change A Front Right Wheel Barren For A 1989 Honda Accord?
- Where Is A Fuel Filter Located On A Holden Frontera 2002?
- Can I Remove The Radiator Overflow Tank On A 2004 Trailblazer?
- How Do I Replace The Key And Tumbler Assembly On The Steering Column Of A Ford F-150?
New Comment - Comments are editable for 5 min.